Dell Wyse Z90DW 설치 매뉴얼 - 페이지 9

{카테고리_이름} Dell Wyse Z90DW에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Wyse Z90DW 24 페이지. Z class cloud clients
Dell Wyse Z90DW에 대해서도 마찬가지입니다: 설치 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (6 페이지)

Installing D Class Flash

Figure 4 Main board and Flash module

7. Remove the existing flash module. Locate the flash module and use the Phillips

Screwdriver to remove its retaining screw as shown in Figure 5. Lift the flash module

out of the socket.

Figure 5 Removing the existing flash module

8. Install the new flash module in the reverse order of removing the original flash

module. Carefully screw down its retaining screw until it is secure.

9. Replace the speaker wire (plug in red wire) and the main-board shield (five screws).

10.Replace the cover in the reverse order as described in step 4 (align the cover screw

tabs with the screw holes and slide the cover toward the front of the thin client).

11., Attach the cover screws in the reverse order as described in step 3.

12.Connect the power cord and power adapter, attach any other cables to the thin

client, and then attach the vertical foot.

CAUTION: Do not turn on the thin client. The thin client is ready to re-image,

however the flash module does not contain an operating system. Turning on power

to your thin client without firmware will display the error message "NO OPERATING

SYSTEM FOUND."

13.Continue with "Installing Firmware."