Dell DX6004S 개요 - 페이지 5

{카테고리_이름} Dell DX6004S에 대한 개요을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell DX6004S 19 페이지. Document
Dell DX6004S에 대해서도 마찬가지입니다: 보충 설명서 (4 페이지), 사용자 설명서 (46 페이지), 설정 및 구성 매뉴얼 (43 페이지), 설치 및 구성 매뉴얼 (35 페이지), 시작하기 매뉴얼 (28 페이지), 공지 사항 (28 페이지), 공지 사항 (20 페이지), 구성 매뉴얼 (9 페이지), 구성 매뉴얼 (9 페이지), 릴리스 노트 (8 페이지), 구성 매뉴얼 (7 페이지), 릴리스 노트 (6 페이지), 릴리스 노트 (5 페이지), 릴리스 정보 (5 페이지), 시작하기 매뉴얼 (49 페이지)

페이지 인쇄

configured cluster name. If the names do not match, no node IP addresses are returned in the

response.

If Scsp-Proxy-Cluster is not present, the request uses the configured cluster name and the list of

node IP addresses reflects the currently known node IPs for that cluster.

In either case, the response metadata includes a response header with the same name containing

the cluster name used by the Proxy.

1.1.1.2. Response Headers

The following table discusses response headers:

Response

Scsp-Proxy-Cluster

Scsp-Proxy-Nodes

Scsp-Proxy-Agent

Castor-System-

TotalGBAvailable, Castor-

System-TotalGBCapacity

For example, the following response indicates there are 10 nodes in the cluster:

Scsp-Proxy-Nodes: count=10

If the response indicates zero nodes in the cluster, it is accompanied by a reason, as follows:

Scsp-Proxy-Nodes: count=0, reason=no-nodes

The following table discusses reason codes.

Reason for empty node list

no-nodes

bad-subnet

bad-cluster

Description

Cluster name (for example, if the cluster is configured on

a CSN, it is the value of scsp.clusterName in /etc/

caringo/scspproxy/scspproxy.cfg).

ASCII string count of the number of node IP addresses

returned in the body of the response. If this count is zero,

an additional reason is supplied to explain why there were

no nodes returned. More information about the zero-node

response is discussed following the table.

Proxy and its software version.

Obtained by polling any available node on the local

cluster. These headers are provided to maintain

consistency with current Proxy and DX Storage

responses.

Meaning

The Proxy reports no nodes when, for example, the cluster is

off-line or is being rebooted.

The request was made from a subnet from which the node IP

addresses are not routable.

The Proxy determines whether or not a request originated from

the same private subnet as its cluster and responds only if the

request did originate in that subnet. The Proxy does this to help

prevent malicious discovery about the cluster and because

private IP addresses are not routable anyway.

The cluster name supplied in the Scsp-Proxy-Cluster

header did not match the currently configured cluster.

Version 1.2

December 2010