Dell E04B 참조 매뉴얼 - 페이지 10

{카테고리_이름} Dell E04B에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell E04B 29 페이지. Bios and uefi

페이지 인쇄

2. Press F2 immediately after you see the following message:

F2 = System Setup

NOTE:

If your operating system begins to load before you press F2, wait for the system to finish booting, and then

restart your system and try again.

3. On the System Setup Main Menu screen, click System BIOS.

4. On the System BIOS screen, click Processor Settings.

Processor Settings details

About this task

The Processor Settings screen details are explained as follows:

Option

Description

Logical Processor Enables or disables the logical processors and displays the number of logical processors. If this option is

set to Enabled, the BIOS displays all the logical processors. If this option is set to Disabled, the BIOS

displays only one logical processor per core. This option is set to Enabled by default.

CPU

Enables you to govern the frequency of the communication links among the CPUs in the system.

Interconnect

Speed

The options available are Maximum data rate, 10.4 GT/s, and 9.6 GT/s. This option is set to Maximum

data rate by default.

Maximum data rate indicates that the BIOS runs the communication links at the maximum frequency that

is supported by the processors. You can also select specific frequencies that the processors support,

which can vary.

For best performance, you should select Maximum data rate. Any reduction in the communication link

frequency affects the performance of nonlocal memory accesses and cache coherency traffic. In addition,

it can slow access to nonlocal I/O devices from a particular CPU.

However, if power-saving considerations outweigh performance, you might want to reduce the frequency

of the CPU communication links. If you do this, you should localize memory and I/O accesses to the

nearest NUMA node to minimize the impact to system performance.

Virtualization

Enables or disables the virtualization technology for the processor. This option is set to Enabled by

Technology

default.

Adjacent Cache

Optimizes the system for applications that need high utilization of sequential memory access. This option

Line Prefetch

is set to Enabled by default. You can disable this option for applications that need high utilization of

random memory access.

Hardware

Enables or disables the hardware prefetcher. This option is set to Enabled by default.

Prefetcher

DCU Streamer

Enables or disables the Data Cache Unit (DCU) streamer prefetcher. This option is set to Enabled by

Prefetcher

default.

DCU IP

Enables or disables the Data Cache Unit (DCU) IP prefetcher. This option is set to Enabled by default.

Prefetcher

Sub NUMA

Sub NUMA Clustering (SNC) is a feature for breaking up the LLC into disjoint clusters based on address

Cluster

range, with each cluster bound to a subset of the memory controllers in the system. It improves average

latency to the LLC. Enables or disables the Sub NUMA Cluster. This option is set to Disabled by default.

UPI Prefetch

Enables you to get the memory read started early on DDR bus. The Ultra Path Interconnect (UPI) Rx path

spawns the speculative memory read to Integrated Memory Controller (iMC) directly. This option is set to

Enabled by default.

LLC Prefetch

Enables or disables the LLC Prefetch on all threads. This option is set to Disabled by default.

Dead Line LLC

When enabled, it opportunistically fill dead lines in LLC. When disabled, it never fill dead lines in LLC. This

Alloc

option is set to Enabled by default.

Pre-operating system management applications

NOTE:

The standard and basic bin processors support lower link frequencies.