Allied Telesis AT-8900 SERIES 빠른 설치 매뉴얼 - 페이지 10

{카테고리_이름} Allied Telesis AT-8900 SERIES에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-8900 SERIES 13 페이지. How to set up pppoe between a linux client and access concentrator
Allied Telesis AT-8900 SERIES에 대해서도 마찬가지입니다: 문제 해결 (5 페이지), 방법 (8 페이지)

페이지 인쇄

Configuring the Switch

Some configuration is necessary to enable the switch's advanced switching

capabilities. This is achieved via the Command Line Interface (CLI).

Using the CLI to configure a switch

Connect a terminal or PC to RJ-45 (ASYN0)

Using the supplied RJ-45 straight-through cable, connect your terminal or

PC to the RS-232 Terminal Port on the switch's front panel.

Set the communication parameters

Set the communication parameters on your terminal or terminal emulation

program to:

•

Bit rate: 9600

•

Data bits: 8

•

Parity: None

•

Stop bits: 1

•

Flow control: Hardware

Check the power supply

For AC models, ensure that the switch is receiving power (PWR LED is lit

green).

For DC models, ensure that the Run/Standby switch is in the On or Run

position and that the switch is receiving power (PWR LED is lit green).

After the switch has booted, the log in prompt appears. If the log in prompt

doesn't appear, press [Enter] two or three times.

When the switch boots for the first time it automatically creates an account

with manager privileges. The account has the log in name "manager" and

the password is "friend".

At the log in prompt, enter the log in name and password.

Password: friend

The switch's command prompt appears. Now configure the switch using

the command line interface.

Change the password as soon as possible. Leaving the manager account with

the default password is a serious security risk. Remember the new password as

there is no way to retrieve it if it is lost.

Use the following command to change the account password:

set password

To display a list of help topics, enter:

help

To display help on a specific topic, enter:

help topic