Dell EMC PowerEdge R550 참조 매뉴얼 - 페이지 12

{카테고리_이름} Dell EMC PowerEdge R550에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC PowerEdge R550 25 페이지.

페이지 인쇄

○ Faster boot time.

NOTE:

You must use only the UEFI boot mode in order to boot from NVMe drives.

● BIOS: The BIOS Boot Mode is the legacy boot mode. It is maintained for backward compatibility.

To view the Boot Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >

Boot Settings.

Table 10. Boot Settings details

Option

Boot Mode

Boot Sequence Retry

Hard-disk Failover

Generic USB Boot

Hard-disk Drive Placeholder

Clean all Sysprep order and variables When this option is set to None, BIOS will do nothing. When set to Yes, BIOS will

UEFI Boot Settings

Choosing system boot mode

System Setup enables you to specify one of the following boot modes for installing your operating system:

● UEFI boot mode (the default), is an enhanced 64-bit boot interface.

If you have configured your system to boot to UEFI mode, it replaces the system BIOS.

1. From the System Setup Main Menu, click Boot Settings, and select Boot Mode.

2. Select the UEFI boot mode you want the system to boot into.

CAUTION:

Switching the boot mode may prevent the system from booting if the operating system is not

installed in the same boot mode.

3. After the system boots in the specified boot mode, proceed to install your operating system from that mode.

Pre-operating system management applications

Description

Enables you to set the boot mode of the system. If the operating system supports

UEFI, you can set this option to UEFI. Setting this field to BIOS allows compatibility

with non-UEFI operating systems. This option is set to UEFI by default.

CAUTION:

Switching the boot mode may prevent the system from

booting if the operating system is not installed in the same boot mode.

NOTE:

Setting this field to UEFI disables the BIOS Boot Settings menu.

Enables or disables the Boot sequence retry feature or resets the system. When If

this option is set to Enabled and the system fails to boot, the system re-attempts

the boot sequence after 30 seconds. When this option is set to Reset and the

system fails to boot, the system reboots immediately. This option is set to Enabled

by default.

Enables or disables the Hard-disk failover. This option is set to Disabled by default.

Enables or disables the generic USB boot placeholder. This option is set to

Disabled by default.

Enables or disables the Hard-disk drive placeholder. This option is set to Disabled

by default.

delete variables of SysPrep #### and SysPrepOrder this option is a onetime option,

will reset to none when deleting variables. This setting is only available in UEFI

Boot Mode. This option is set to None by default.

Specifies the UEFI boot sequence. Enables or disables UEFI Boot options.

NOTE:

This option controls the UEFI boot order. The first option in the list will

be attempted first.

Table 11. UEFI Boot Settings

Option

UEFI Boot Sequence

Boot Options Enable/Disable

Description

Enables you to change the boot device

order.

Enables you to select the enabled or

disabled boot devices