Dell EMC PowerEdge R940 서비스 - 페이지 4
{카테고리_이름} Dell EMC PowerEdge R940에 대한 서비스을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC PowerEdge R940 14 페이지. Upgrading the dual processor to quad processor system
Dell EMC PowerEdge R940에 대해서도 마찬가지입니다: 지침 (10 페이지)
페이지 인쇄
Upgrading from dual processor to quad
processor configuration
For more information on upgrading the dual processor to quad processor configuration, watch the video at
www.Dell.com/QRL/PER940/2S-to-4S-Upgrade
Figure 1. QRL for 2S to 4S processor configuration upgrade
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the
online or telephone service and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that are shipped with your
product.
CAUTION: The Processor Expansion Module (PEM) processors and DIMMs must be installed after the
PEM is installed into the chassis. Failure to do so may result in the PEM getting damaged.
•
Turn off the system and disconnect any attached peripherals.
•
Always wear ESD protection when working inside the system.
•
Torx #T30 tool required.
•
Flat head or Phillips #2 screwdriver.
NOTE: All DIMM sockets are required to have either DIMMs or DIMM blank installed.
NOTE: It is recommended to order a heat sink along with every new processor ordered.
1.
Using a flat head or Phillips #2 screwdriver, rotate the latch release lock counter clockwise to the unlocked
position on the system cover.
2.
Lift the latch until the system cover slides back and the tabs on the system cover disengage from the guide
slots on the system.
4