Dell EMC VxRail S Series 소유자 매뉴얼 - 페이지 30
{카테고리_이름} Dell EMC VxRail S Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMC VxRail S Series 32 페이지.
페이지 인쇄
DIMM Type
DIMMs Populated/
Channel
LRDIMM
1
2
3
General memory module installation guidelines
NOTE:
Memory configurations that fail to observe these guidelines can prevent your appliance from booting, stop responding
during memory configuration, or operating with reduced memory.
The appliance supports Flexible Memory Configuration, enabling the appliance to be configured and run in any valid chipset architectural
configuration. The following are the recommended guidelines for installing memory modules:
•
RDIMMs and LRDIMMs must not be mixed.
•
x16 and x32 DRAM based memory modules can be mixed.
•
Up to three dual- or single-rank RDIMMs can be populated per channel.
•
Up to three LRDIMMs can be populated per channel regardless of rank count.
•
If memory modules with different speeds are installed, they will operate at the speed of the slowest installed memory module(s) or
slower depending on appliance DIMM configuration.
•
Populate memory module sockets only if a processor is installed. For single-processor systems, sockets A1 to A12 are available. For dual-
processor systems, sockets A1 to A12 and sockets B1 to B12 are available.
•
Populate all the sockets with white release tabs first, followed by the black release tabs, and then the green release tabs.
•
Mixing of more than two memory module capacities in a appliance is not supported.
•
When mixing memory modules with different capacities, populate the sockets with memory modules with highest capacity first. For
example, if you want to mix 16 GB and 32 GB memory modules, populate 32 GB memory modules in the sockets with white release
tabs and 16 GB memory modules in the sockets with black release tabs.
•
In a dual-processor configuration, the memory configuration for each processor should be identical. For example, if you populate socket
A1 for processor 1, then populate socket B1 for processor 2, and so on.
•
Memory modules of different capacities can be mixed provided other memory population rules are followed (for example, 16 GB and 32
GB memory modules can be mixed).
•
Mixing of more than two memory module capacities in a appliance is not supported.
•
VxRail Appliances require that you populate four memory modules per processor (one DIMM per channel) at a time to maximize
performance.
Expansion cards and expansion card riser
An expansion card in the appliance is an add-on card that can be inserted into an expansion slot on the system board or riser card to add
enhanced functionality to the appliance through the expansion bus.
NOTE:
To avoid data loss, ensure that you refer to the procedures in the SolVe Desktop application before performing any
memory or expansion card replacement or upgrade procedures.
NOTE:
A System Event Log (SEL) event is logged if an expansion card riser is unsupported or missing. It does not prevent your
appliance from turning on and no BIOS POST message or F1/F2 pause is displayed.
Expansion card guidelines
Your appliance supports PCI Express Generation 3 expansion cards.
30
Replacing and adding hardware
Operating Frequency (in
Voltage
2400, 2133, 1866
1.2 V
2400, 2133, 1866
2133, 1866
Maximum DIMM Rank/Channel
MT/s)
Quad rank
Quad rank
Quad rank