Dell EMP 사용자 설명서 - 페이지 11

{카테고리_이름} Dell EMP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell EMP 20 페이지. Dell poweredge ups 500t server - environmental monitoring probe (emp) installation
Dell EMP에 대해서도 마찬가지입니다: Emp 설치 (2 페이지)

페이지 인쇄

2 Locate the Ethernet cable (supplied). Connect one end of the cable to the RJ-45 port on the EMP,

then connect the other end to the Settings port on the Network Management Card (see Figure 4).

Figure 4. Connecting the Cable

NOTE:

If the configuration cable is still attached to the Network Management Card, remove and store it for

future use.

NOTE:

If the supplied cable is not long enough for your installation, you can use another Ethernet cable up to

a length of 10m (33 ft).

3 The EMP can be mounted to the wall or the rack post, or placed on the UPS.

•

The EMP has a universal slot on the rear for easy mounting on a screw in any direction. Use the

supplied screw and anchor to mount the EMP.

•

To mount the EMP to the rack post, attached one VELCRO

VELCRO fastener to the EMP. Press the two VELCRO strips together to secure the EMP to the

rail post.

4 Use the supplied tie wraps to secure the Ethernet cable out of the way as needed.

5 Verify that the Network Management Card has a network connection, is installed in a UPS, and the

UPS is plugged in and turned on. The EMP is automatically recognized by the Network Management

Card.

NOTE:

If the Environment menu does not display on the menu bar, click your Web browser's Refresh button to

update the page.

EMP

Network Management Card

fastener to the rail and the other

Installation