Allied Telesis AT-8948 빠른 설치 매뉴얼 - 페이지 5

{카테고리_이름} Allied Telesis AT-8948에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-8948 13 페이지. At-8900 series
Allied Telesis AT-8948에 대해서도 마찬가지입니다: 데이터시트 (4 페이지), 데이터시트 (3 페이지), 데이터시트 (3 페이지), 데이터시트 (2 페이지), 데이터시트 (5 페이지), 개요 (1 페이지), 구성 방법 (9 페이지), 브로셔 (8 페이지), 보충 설명서 (6 페이지)

페이지 인쇄
Allied Telesis AT-8948 빠른 설치 매뉴얼
Quick Install Guide
C613-04048-01 REV B

Installing the Switch

This equipment must be earthed.
Follow these steps to install the switch:
1.
Read the safety information
For safety information, see the Safety and Statutory Information booklet. A
copy of this booklet is supplied with each switch, and can also be found on
the Documentation and Tools CD-ROM or at
http://
www.alliedtelesyn.co.nz/support/at8900.
2.
Gather the tools and equipment you will need
If installing a switch with a DC PSU, you will need an appropriate DC
power source, DC supply cable, ring connectors, and a crimp tool.
3.
Choose a suitable site for the switch
Either a 19 inch rack, a flat bench, or a wall.
4.
Unpack the switch
Verify the package contents. If any items are damaged or missing, contact
your sales representative.
5.
Place the switch in its operating location
See the previous "Selecting a Site" section for guidelines on choosing a
suitable location.
To install the switch using the 19 inch rack-mount kit:
•
Ensure the rack has sufficient space for the switch and its associated
cables.
•
Remove the rubber feet from the switch.
•
Screw the brackets to the sides of the switch using the supplied M4
screws (see Figure 1).
•
Fit the adjustable bracket extension onto the rear bracket but do not
fully tighten the nuts. You may need to adjust the position of the
extension bracket to correctly fit the switch into the rack (see Figure 1).
•
Mount the switch in the rack using appropriate rack mounting screws
(not supplied).
5