Dell Force10 MXL Blade 시작하기 매뉴얼 - 페이지 14
{카테고리_이름} Dell Force10 MXL Blade에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 MXL Blade 38 페이지. 10/40gbe blade switches
Dell Force10 MXL Blade에 대해서도 마찬가지입니다: 애플리케이션 노트 (6 페이지), 사양 (2 페이지), 매뉴얼 (27 페이지)
페이지 인쇄
Unpacking the Switch
Package Contents
When unpacking each switch, make sure that the following items are
included:
•
One Dell Force10 MXL 10/40GbE Switch IO Module
•
One USB type A-to-DB-9 female cable
•
Getting Started Guide
•
Safety and Regulatory Information
•
Warranty and Support Information
•
Software License Agreement
Unpacking Steps
NOTE:
Before unpacking the switch, inspect the container and immediately report any
evidence of damage.
1 Place the container on a clean, flat surface and cut all straps securing the
container.
2 Open the container or remove the container top.
3 Carefully remove the switch from the container and place it on a secure
and clean surface.
4 Remove all packing material.
5 Inspect the product and accessories for damage.
Installing and Configuring the
Switch
After you unpack the MXL 10/40GbE Switch, refer to the flow chart in
Figure 1-6 for an overview of the steps you must follow to install the blade
and perform the initial configuration.
You can check to see that a switch is running the latest FTOS version by entering
the show version command. To download an FTOS version, go to
14
Installing and Configuring the Switch
http://support.dell.com
.