Dell Force10 S2410 빠른 시작 매뉴얼 - 페이지 22

{카테고리_이름} Dell Force10 S2410에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S2410 31 페이지. Installing the s2410 system
Dell Force10 S2410에 대해서도 마찬가지입니다: 매뉴얼 (42 페이지)

페이지 인쇄

Step Task

Invoke the (Config-if-ma)#

prompt.

Set the IP address and subnet

mask of the management

interface.

NOTE: Creating a management IP address is supported by both the Layer 2

(Switching) and Layer 3 (Routing) licenses of SFTOS.

By default, the management address is reachable from all ports on the default

VLAN, VLAN 1. One or more ports in that VLAN must be enabled.

After you enable and connect ports in the management VLAN and configure the

management IP address, you can manage the switch through a variety of means.

Configure a Username and Password

The username passwd command creates the username and password in one

statement. You can change a password either by reentering the command with

the new password or by removing the user with the no username command and

reentering the user with a new password.

Step Task

Configure a username and

password.

Removing a username.

Configure the Enable Password

The Privileged Exec password (commonly called the "enable" password), is not

set when the S2410 starts for the first time. To set the enable password, access

the Privileged Exec mode (also called "enable mode") and then the Global

Config mode. Enter the enable passwd command, then press Enter.

Installing the Software

Command Syntax

interface

managementethernet

ip address ipaddr

subnetmask

Command Syntax

username passwd

no username

Command Mode

Global Config

(Config-if-ma)#

prompt within the

Global Config

mode

Command Mode

Config