Dell Force10 S2410 매뉴얼 - 페이지 21
{카테고리_이름} Dell Force10 S2410에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S2410 42 페이지. Installing the s2410 system
Dell Force10 S2410에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (31 페이지)
페이지 인쇄Supplying Power
NOTE: The power supply cord is used as the main disconnect device; ensure that the socket-outlet is located/
installed near the equipment and is easily accessible.
Both S2410 models (S2410CP and S2410P) provide built-in dual AC power supplies. Only one power
supply is needed for the unit to operate. However, if both power supplies are connected, the S2410 uses
power from both power supplies in load-sharing mode. There are no DC power or backup power options.
The power cords shipped by default with the S2410 chassis are for the United States. Several versions of
the power cord are available, based on country requirements.
Connect the power cord plugs to the AC receptacles at each rear corner of the S2410, as shown in
Figure 2-2 on page
7, making sure the cords are secure. Connecting either power cord to power starts the
system (no on/off switch).
Power supply replacement is not offered as an option in the field.
NOTE: The AC receptacles are labeled A and B, matched to the PSU A and PSU B status LEDs on the face
of the S2410. Labeling the power cords A and B can help in a diagnostic situation.
Where Do I Go from Here?
The S2410 is unique among S-Series switches in several aspects:
• It has no stacking functionality.
• It has a dedicated Ethernet Management port (commonly called the service port), in addition to the
standard console port and virtual management Ethernet port on VLAN 1.
• It has no optional modules.
• It uses only the SFTOS 2.4.1.x software release.
The next chapter
(Chapter , Accessing Ports, on page
management terminal, so that you can use the Command Line Interface (CLI) to configure system
preferences, ports, and alternative management interfaces.
Whether you have an S2410P, which contains 24 XFP ports, or an S2410CP, which contains four XFP
ports, you need to install XFP transceivers (not included with the switch) before connecting the optical
cables. See
Accessing XFP Ports on page
For more on using management interfaces, see the S2410 Quick Reference or the Getting Started chapter
of the SFTOS Configuration Guide (SFTOS 2.4.1.0).
23) discusses connecting the console port to a
25. Alternatively, see
Accessing CX4 Ports on page
24.
Installing the S2410
|
21