Dell Force10 S25 Series 구성 매뉴얼
{카테고리_이름} Dell Force10 S25 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S25 Series 8 페이지. Basic layer 2 setup and buffer tuning of the s25p for storage environments
Dell Force10 S25 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (27 페이지)
페이지 인쇄
Basic Layer 2 Setup and Buffer Tuning of the
S25P for Storage Environments
Introduction
This document is intended for the users of S-Series S25P switches running FTOS 7.8.1.0 and configured
for use in a storage environment. This document describes:
•
Using the console port to enable all ports on the switch for Layer 2 switching
•
Verifying that the installed FTOS software is FTOS 7.8.1.0
•
Setting up passwords for managing the switch. For details on management, see the Management
chapter in the FTOS Configuration Guide for the S-Series and the Control and Monitoring chapter in
the FTOS Command Reference for the S-Series.
•
Optimizing the buffer for use in pure storage environments
This document does not cover:
•
Installing optional modules. For installation details, see the document Installing S25P Systems. For a
configuration example, see
•
Adding the switch to an S-Series stack. For stacking configuration details, see the Stacking chapters in
the Configuration Guide and the Command Reference listed above.
•
Layer 3 (IP addressing) configuration. For details, see the Interfaces and IP Addressing chapters in the
Configuration Guide and Interface Commands chapter in the Command Reference listed above.
The full S-Series documentation set is available on the Technical Documentation CD-ROM and from the
Documentation tab of iSupport at the Force10 Networks website:
https://www.force10networks.com/CSPortal20/KnowledgeBase/Documentation.aspx
This document contains the following sections:
•
Accessing the Console Port on page 2
•
Setting Up Passwords on page 3
•
Setting Up Layer 2 Switching on page 4
•
Managing the Buffer Profile and Setting up Flow Control on page 5
101-00337-00
Figure 7 on page 6
here.
1