Dell Force10 S25P 매뉴얼 - 페이지 11
{카테고리_이름} Dell Force10 S25P에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Force10 S25P 48 페이지. Installing the s25p system
Dell Force10 S25P에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (27 페이지)
System Status
S25P status can be derived in several ways, including physical LED displays and boot menu options, both
discussed here, along with CLI
Command Reference and Configuration Guide for your software (FTOS or SFTOS).
LED Displays
As shown in
Figure
•
Stack ID: This is the LED at the far left of the front panel labeled "STACK ID". See Stack ID in
Table
3. For more on unit numbering, see
•
Status indicator LEDs on the left side of the front panel, described in
•
Each port has status indicator LEDs, described in
Table 3 Port LED Displays
Feature
*
10/100/1000 Port LED
*
SFP Port LED
XFP Port LED
*
The LEDs for a 10/100/1000 copper port (numbered 21 through 24) are inactive if the shared SFP port (also labeled 21 through 24)
.
is enabled
Note: As suggested by the footnote above, the fiber SFP ports have priority over the four 10/100/1000
ports with the same number.
Installing the S25P System
commands,and SNMP traps. For details on those options, see the
show
1, the S25P front panel contains several sets of LEDs:
Description
Speed LED (left side of each port)
Green — A valid 1000Mbps link is established on this port.
Amber — A valid 100Mbps link is established on this port.
Off — No link or a valid 10Mbps link is established on this port.
Link/Active LED (right side of each port)
Green — Link up on this port
Blinking Green — Activity, transmitting, or receiving packet at this port
Off — No link detected at this port
Link/Activity LED
Green — A valid 1000Mbps link is established on this port.
Blinking Green — Activity, transmitting or receiving packet in link up state
Solid Amber– A valid 100Mbps link is established on this port.
Blinking Amber – Activity, transmitting, or receiving packet in link up,
100Mbps state.
Off — No link detected at this port
Link/Activity LED (Each XFP port has a status LED on the module and in the Status
Display at the left front of the switch)
Green — Link up on this port
Blinking Green — Activity, transmitting or receiving packet in link up state
Off — No Link detected at this port
Stacking on page
24.
Table
3.
Table
4.
11