Dell PowerConnect M8428-k 매뉴얼 - 페이지 18
{카테고리_이름} Dell PowerConnect M8428-k에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerConnect M8428-k 25 페이지. Dell poweredge m710 and m710hd - system memory update
Dell PowerConnect M8428-k에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (32 페이지), 릴리스 정보 (27 페이지), 사용자 설명서 (23 페이지), 업데이트 매뉴얼 (1 페이지)
페이지 인쇄
Rev 1.00
3.7
Port Commands
3.7.1 set port test (ADMIN)
Synopsys:
set port test port_number [prbs31 on|off|start|stop]
Description:
Configure test mode on a port. Test mode is used to measure link quality and calibrate link tuning parame-
ters.
• port_number: downlink port number on which to enable / disable test mode
• prbs31: industry-standard pseudo-random binary sequence for link tuning
- prbs31 on: move the port to test mode
- prbs31 start: initalize prbs31 mechanism and start error counting
- prbs31 stop: terminate prbs31 error counting
- prbs31 off: move the port back to operational mode
After "prbs31 on" and before "prbs31 start", configure prbs31 on the remote peer.
Note:
Example:
& set port test 6 prbs31 on
& # enable prbs31 on remote peer now
& set port test 6 prbs31 start
& show port test 6
port 6 prbs31 on: 0 errors
& set port test 6 prbs31 stop
& set port test 6 prbs31 off
3.7.2 show port link
Synopsys:
show port link [port_number]
Description:
This command displays detailed port information. If an uplink port number is specified
([port_number]), then the command displays information only for this port; otherwise, the com-
mand displays information for all the ports.
The command displays the following information per port:
• Port number
• Port group identifier and speed: A, B, followed by the configured speed (10G)
• Pass through connection status, may have one of the following values:
down - either uplink or downlink is not connected
18
Software User's Manual