DH Lifelabs Aaira Surface 사용 설명서 - 페이지 6

{카테고리_이름} DH Lifelabs Aaira Surface에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DH Lifelabs Aaira Surface 9 페이지.

페이지 인쇄

Operating Procedures

Place the pitcher on the base.

Add 1000ml/33.81 oz. of tap water.

Add salt:

• 2 scoops of non-iodized salt for low concentration HOCl disinfectant

• 4 scoops of non-iodized salt for high concentration HOCl disinfectant

Add 4ml/0.14oz. of 5% white vinegar. Use the cap of the salt bottle as a

measuring cup.

Using the stirring stick, vigorously stir the water for 10 seconds to fully dissolve

the salt. NOTE: If you do not adequately stir the water, salt may accumulate on

the electrolysis pad.

Place the lid on the pitcher.

Plug the power supply into the unit. You will hear a power up chime sound

and the LED in the base will light up. After three seconds, the LED will go out

indicating that the unit is in standby mode.

Press the Function Button on either the low concentration (left) side or the high

concentration (right) side to begin the HOCl generation process.

The LED in the base will illuminate (green for low concentration or blue for

high concentration) and then slowly pulse, indicating that the HOCl generation

process is underway.

NOTE: If you wish to cancel the process at any time, press and hold any part of

the function button for two seconds and the unit will return to standby mode.

10.

The electrolysis process will take 9 minutes for low concentration HOCl and 12

minutes for high concentration HOCl. When the process is complete, you will

hear the shutdown chime sound and the base LED will go out.

11.

Your HOCl disinfectant is now ready for use. You can fill the spray bottle with

the HOCl disinfectant, remove the safety clip and begin using it for cleaning,

deodorizing, or disinfecting. Do not overfill or underfill the spray bottle for best

effectiveness.

NOTE: The HOCl disinfectant will lose effectiveness over time. You should

discard it after 1-2 days and process a new batch.

Control Panel

Low Concentration

HOCl Disinfectant (100 PPM)

Where to Use

Remove heavy deposits from

surfaces before using the HOCl

disinfectant. Be sure to test

HOCl in a small, inconspicuous

area before using to ensure

discoloration does not occur.

High Concentration

HOCl Disinfectant (200 PPM)

Everyday Use

Low Concentration (100 PPM)

Clean high-touch areas and

surfaces including but not limited to

countertops, tabletops, appliances,

cabinets, doors and windows.

Disinfectant

High Concentration (200 PPM)

Heavy duty cleaning areas

including but not limited to

bathtubs, showers, toilets, floors,

sinks and drains.