Dell PowerEdge 1650 매뉴얼 - 페이지 9

{카테고리_이름} Dell PowerEdge 1650에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 1650 15 페이지. Installing an era/o card
Dell PowerEdge 1650에 대해서도 마찬가지입니다: 사용 설명서 (6 페이지), 정보 업데이트 (44 페이지), 정보 업데이트 (44 페이지), 설치 매뉴얼 (44 페이지), 설치 매뉴얼 (44 페이지), 설치 매뉴얼 (44 페이지), 설치 매뉴얼 (44 페이지), 설치 매뉴얼 (44 페이지), 사용자 설명서 (34 페이지)

enabled. The displayed Ethernet Address will match the MAC address

obtained while using IBAUTIL.EXE.

6. Choose the Advanced Tab. In the settings frame, choose Enable PME and

change the value to Enabled.

7. Click OK. Windows NT 4.0 will prompt for a reboot. Choose Yes.

8. After the system has restarted, if the NIC is not already connected to a switch

or hub, connect it and shut the system down.

9. Shut the system off. The connection LED on the NIC and switch or hub will

remain on indicating the NIC is monitoring the network for wake up packets

directed to its MAC address.

10. Send a wake up signal to the MAC address of the WOL enabled NIC, and the

system will boot.

Note: If the system boot is interrupted before the OS and the NIC driver are loaded, the

system will not be able to perform WOL again until the system is rebooted manually and

the OS and driver are allowed to load and reset the NIC's WOL registers.

October 2007

Page 9

Dell Enterprise Product Group