Dell PowerEdge 1855 빠른 시작 매뉴얼 - 페이지 10
{카테고리_이름} Dell PowerEdge 1855에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 1855 12 페이지. Using dell blade servers in a dell poweredge high availability cluster
Dell PowerEdge 1855에 대해서도 마찬가지입니다: 정보 업데이트 (2 페이지), 매뉴얼 사용 (44 페이지), 사용자 설명서 (33 페이지)
페이지 인쇄
c.
Reenable the switch by entering the switchEnable command.
Note
It could take a short time (typically a few seconds but sometimes a little longer) for the
newly added switch to appear in the fabric display with its newly assigned domain ID.
7.
Install the SFP transceivers as required.
a.
Remove the dust plugs from the ports to be used as well as any end caps from.
b.
Position a transceiver so that it is oriented correctly and insert it into a port until it is firmly seated and the
latching mechanism clicks.
For instructions specific to the type of transceiver, refer to the transceiver manufacturer's documentation.
c.
Repeat steps a and b for the remaining ports, as required.
8.
Connect the cables to the transceivers.
The transceivers are keyed to ensure correct orientation. If a transceiver does not install easily, ensure that it is
correctly oriented.
The cables used in trunking groups must meet specific requirements. For a list of these requirements, refer to the
Brocade Fabric OS Administrator's Guide.
Caution
A 50-micron cable should not be bent to a radius less than 2 inches under full tensile load and 1.2 inches with
no tensile load.
a.
Orient a cable connector so that the key (the ridge on one side of connector) aligns with the slot in the transceiver.
Then, insert the cable into the transceiver until the latching mechanism clicks. For instructions specific to cable
type, refer to the cable manufacturer's documentation.
b.
Repeat this procedure for the remaining transceivers.
9.
Check the LEDs to verify that all components are functional. For information about LED patterns, refer to the
SilkWorm 4016 Hardware Reference Manual.
10. Verify the correct operation of the SilkWorm 4016 by typing the switchShow command from the workstation,
followed by the fabricShow command.
10 of 12
SilkWorm 4016 Quickstart Guide
Publication Number: Publication Number: 53-100051-01