Dell PowerEdge 1950 설치 매뉴얼 - 페이지 3

{카테고리_이름} Dell PowerEdge 1950에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 1950 10 페이지. Trusted platform module (tpm) update
Dell PowerEdge 1950에 대해서도 마찬가지입니다: 정보 업데이트 (50 페이지), 설치 정보 (11 페이지), 업데이트 (2 페이지)

페이지 인쇄

Installing a SATA Optical Drive

These instructions apply to Dell™ PowerEdge™ systems to which a SATA

optical drive is being added, or in which an existing PATA or IDE optical drive

is being replaced by a SATA optical drive.

WARNING:

cover and access any of the components inside the system. Before you begin this

procedure, review the safety instructions that came with the system.

Removing an Existing Optical Drive – All Systems

1 Turn off the system and attached peripherals, and disconnect the system

from the electrical outlet.

2 Remove the bezel. See "Removing the Bezel" in your Hardware Owner's

Manual.

3 Remove the system cover. See "Opening the System" in your Hardware

Owner's Manual.

4 PowerEdge 1950 systems only: Disconnect and remove the SAS controller

daughter card. See "Removing a SAS Controller Daughter Card" in your

Hardware Owner's Manual.

5 Disconnect the data and power cables from the back of the optical drive.

6 PowerEdge 2900 and 1900 systems only: Perform the following steps. See

your Hardware Owner's Manual for specific step instructions.

Disconnect the SAS cable from the SAS controller and pull the cable

away from the center fan bracket.

Remove the center fans and the center fan bracket.

Release the spring latch at the top of the peripheral bay and remove

the optical drive from the front of the bay.

7 For systems with a drive tray, release the blue tab at the back of the tray

and slide the drive tray out of the system.

Only trained service technicians are authorized to remove the system

Installing a SATA Optical Drive