Dell PowerEdge 2400 랙 설치 지침 - 페이지 15
{카테고리_이름} Dell PowerEdge 2400에 대한 랙 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2400 32 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2400에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지), 설치 매뉴얼 (8 페이지), 업데이트 (2 페이지), 활성화 매뉴얼 (8 페이지), 설치 매뉴얼 (8 페이지), 업데이트 매뉴얼 (2 페이지), 매뉴얼 (15 페이지)
페이지 인쇄
support.dell.com
Before You Begin
Before you begin installing your PowerEdge system in the rack, carefully read
"Safety Instructions" found earlier in this guide.
Recommended Tools
To install the rack kit, you need the following tools:
•
Installation template
•
A #2 Phillips-head screwdriver
•
A flat-blade screwdriver
•
Masking tape or felt-tip pen
Installing the Rack Kit
NOTES: If you purchased a Dell rack along with your PowerEdge system, the slide
assemblies may be preinstalled in the rack.
For instructions on installing the PowerEdge system itself, see "Installing the
PowerEdge System in the Rack" found later in this guide.
To install the slide assemblies in the rack, perform the following steps:
1.
Remove the rack's front and back doors.
2.
Install the slide assemblies in the rack.
The subsections that follow include instructions for performing these tasks.
Removing the Doors From a 24-U or 42-U Rack
You must remove the doors from the rack to provide access to the interior of the rack
and to prevent damage to the doors while installing the kit. To remove the doors,
perform the following steps.
CAUTION: To prevent personal injury due to the size and weight of the
doors, never attempt to remove the doors by yourself.
1.
Open the latch on the front door. If you have a 24-U (1 U=1.75-inches) rack cabi-
net, unlock and twist the handle clockwise and open the door (see Figure 1-2).
Dell PowerEdge 2400 Systems Rack Installation Guide
1-3