Dell PowerEdge 2450 설치 매뉴얼 - 페이지 18

{카테고리_이름} Dell PowerEdge 2450에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2450 20 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2450에 대해서도 마찬가지입니다: 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (32 페이지), 정보 업데이트 (12 페이지), 보충 설명서 (30 페이지), 하드웨어 설치 매뉴얼 (32 페이지), 소프트웨어 설명서 (10 페이지), 설치 매뉴얼 (8 페이지), 매뉴얼 (15 페이지)

페이지 인쇄
Dell PowerEdge 2450 설치 매뉴얼
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
1-14
Microprocessor Upgrade Installation Guide
5.
Pivot the retention clips away from the guide-bracket assembly.
6.
Slide the terminator card out of the guide-bracket assembly.
,QVWDOOLQJ D 7HUPLQDWRU &DUG
To install a terminator card in the guide-bracket assembly, perform the following steps:
1.
Slide the terminator card into the guide-bracket assembly until the edge connec-
tor on the terminator card is firmly seated in the connector on the system board.
2.
Place the retention clips on each end of the guide bracket in the notches on the
ends of the guide bracket, and then close the two latches to secure the termina-
tor card in the bracket.
5HPRYLQJ WKH 6(& &DUWULGJH DQG +HDW 6LQN $VVHPEO\
To remove the SEC cartridge and heat sink assembly, perform the following steps.
,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ *XLGH
1.
Turn off the system, including any attached peripherals, and disconnect the AC
power cable from its power source.
*XLGH
2.
Remove the computer cover.
3.
Remove the cooling shroud.
4.
Lift the latches on each end of the guide-bracket assembly.
5.
Pivot the retention clips away from the guide-bracket assembly.
6.
Slide the SEC cartridge and heat sink assembly out of the guide-bracket
assembly.
DELL CONFIDENTIAL - Preliminary
'HOO 3RZHU(GJH 6\VWHPV
,QVWDOODWLRQ DQG 7URXEOHVKRRWLQJ
9/11/00