Dell PowerEdge 2450 보충 설명서 - 페이지 6

{카테고리_이름} Dell PowerEdge 2450에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2450 30 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2450에 대해서도 마찬가지입니다: 설치 매뉴얼 (26 페이지), 설치 매뉴얼 (32 페이지), 설치 매뉴얼 (20 페이지), 정보 업데이트 (12 페이지), 하드웨어 설치 매뉴얼 (32 페이지), 소프트웨어 설명서 (10 페이지), 설치 매뉴얼 (8 페이지), 매뉴얼 (15 페이지)

1-4

Dell PowerEdge 2450 Systems SCSI Backplane Daughter Card

(Rev. 11/3/98) FILE LOCATION: C:\Dell\docs\2450\scsi\205FYeb1.fm

Position the card in the drive bay so that the notches on the left and right

edges of the card are aligned with the tabs on the card guide in the drive bay.

Lower the card into the card guide.

7 .

Slide the daughter card into the drive bay and lock the card into place by closing

the retention lever on the card's front edge (see Figure 1-4).

The four connectors on the SCSI backplane board are designated as SCSI ID 0

through SCSI ID 3 (see Figure 1-1). If a fifth hard-disk drive is installed in the

peripheral bay, it is identified as SCSI ID 4.

To configure the drives in a split 2 x 2 configuration (1 x 2 and 1 x 3 in a five-drive

system), you must connect two SCSI host adapters to the SCSI backplane board.

The host adapter attached to connector SCSIB on the backplane controls slots

SCSI ID 0 and SCSI ID 1, while the host adapter connected to connector SCSIA

controls slots SCSI ID 2, SCSI ID 3, and the fifth drive slot, SCSI ID 4 (see

Figure 1-5).

Ultra3 SCSI cable connector (SCSIA)

Figure 1-5. SCSI Cable Connectors on the SCSI Backplane Board

Reinstall the hard-disk drives in the right-hand drive bays and install the hard-disk

drive lock if desired.

10. Close the computer covers.

11. Reconnect the computer and peripherals to their AC power sources.

DELL CONFIDENTIAL - Preliminary

Ultra3 SCSI cable connector (SCSIB)

9/27/01