Dell PowerEdge 2500 설치 매뉴얼 - 페이지 3

{카테고리_이름} Dell PowerEdge 2500에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2500 10 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2500에 대해서도 마찬가지입니다: 구성 매뉴얼 (10 페이지), 활성화 매뉴얼 (24 페이지), 첨부 파일 매뉴얼 (10 페이지), 매뉴얼 (15 페이지)

페이지 인쇄

1 x 2 Backplane Installation

This document provides instructions for installing a 1 x 2 backplane kit to add provisions for

up to two additional 1-inch small computer system interface (SCSI) hard-disk drives in a

Dell™ system's peripheral bay.

1 x 2 Backplane Kit Contents

The 1 x 2 backplane kit includes the following items:

•

A 1 x 2 backplane attached to an assembled drive cage

•

Four 6-32 x 0.25-inch hex-head Phillips screws

•

Inter-integrated circuit (I

•

Nonterminated SCSI cable that links the 1 x 2 backplane to the system board

Before You Begin

WARNING: Before you perform this procedure, you must turn off the system and

disconnect it from its power source. For more information, read the safety

precautions in your System Information document.

WARNING: Your system may have more than one power supply cable. To reduce

the risk of electrical shock, you must disconnect all power supply cables before

servicing the system. For more information, see "Safety First—For You and Your

Computer" in your Installation and Troubleshooting Guide .

Turn off the system, including any attached peripherals, and disconnect the system

from the electrical outlet.

CAUTION: See "Protecting Against Electrostatic Discharge" in the safety

instructions in your System Information document.

Unpack the 1 x 2 backplane kit.

Remove the front bezel (see "Removing the Front Bezel" in your Installation and

Troubleshooting Guide).

Remove the system cover (see "Removing the System Cover" in your Installation and

Troubleshooting Guide).

NOTE: Verify that your system has the latest basic input/output system (BIOS)

revision and firmware. Download the latest revision from the Dell support site at

http://support.dell.com.

C) extension cable

1 x 2 Ba ckplane Ki t Inst allat ion Gu i d e

1-1