Dell PowerEdge 2500 설치 매뉴얼 - 페이지 8
{카테고리_이름} Dell PowerEdge 2500에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2500 10 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 2500에 대해서도 마찬가지입니다: 구성 매뉴얼 (10 페이지), 활성화 매뉴얼 (24 페이지), 첨부 파일 매뉴얼 (10 페이지), 매뉴얼 (15 페이지)
페이지 인쇄
NOTICE: The I
Route the I
3
Figure 1-3).
Attach the 10-pin connector on the I
4
(PLANAR_1X2) on the 1 x 2 backplane.
Attach the 20-pin connector on the end of the I
5
connector on the system board (PLANAR).
Attach the free end of the I
6
step 1, to the middle connector on the new I
steps 3 and 4.
Attach a four-wire power cable to the power connector (J1) on the 1 x 2 backplane (see
7
Figure 1-3).
NOTE: The four-wire power cable is the standard cable found on all systems and provides power
to peripherals, such as a tape drive.
Installing the SCSI Cable
NOTE: The SCSI cable installation described in this document is a typical installation of the
SCSI cable used with the 1 x 2 backplane. You can install the SCSI cable differently, depending
on redundant array of independent disks (RAID) configurations and the existence of SCSI
peripheral cards. Refer to your operating system documentation for information on how to set up
your SCSI devices.
To connect the SCSI cable to the 1 x 2 backplane, perform the following steps:
In the customer kit, locate the nonterminated 68-pin SCSI cable. This cable has one
1
connector on one end and two connectors on the other end (see Figure 1-3).
Route the SCSI cable through the clips on top of the cooling shroud (see Figure 1-3).
2
On the end with two connectors:
3
a
b
Attach the end with one connector to the SCSIB connector on the system board.
4
You can also connect this end of the cable to a Peripheral Component Interconnect
(PCI) SCSI or PCI RAID controller card.
1-6
1 x 2 Backplane K it Inst al lat ion Gui de
2
C cable must be routed over the top of the cooling shroud.
2
C extension cable through the clips on the top of the cooling shroud (see
2
Attach the connector on the end of the cable to the vertical connector that is
2
closest to the 10-pin I
C connector on the 1 x 2 backplane (see Figure 1-3).
Attach the next-to last connector on the cable to the remaining vertical connector
on the 1 x 2 backplane (see Figure 1-3).
2
C extension cable to the 10-pin connector
2
C extension cable to the 20-pin
C cable, which was disconnected from the system board in
2
C extension cable that you installed in