Dell PowerEdge 2850 보충 설명서 - 페이지 7
{카테고리_이름} Dell PowerEdge 2850에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2850 20 페이지. Dell server quick reference
Dell PowerEdge 2850에 대해서도 마찬가지입니다: 설치 매뉴얼 (32 페이지), 지원 매트릭스 (21 페이지), 정보 업데이트 (24 페이지), 매뉴얼 (44 페이지), 빠른 참조 (2 페이지), 사용자 설명서 (30 페이지)
페이지 인쇄
Removing and Replacing the System Board and Riser Board
In A Dell PowerEdge 2850 System
Removing the System Board
1
If applicable, remove the bezel.
2
Turn off the system and attached peripherals, and disconnect the system from the electrical
outlet and peripherals.
3
Remove the system from the rack and place it on a work surface.
4
Remove the system cover.
5
Remove the front fans.
6
Remove the expansion cards. See "Expansion Cards" in "Installing System Options" in your
Installation and Troubleshooting Guide.
7
If applicable, disconnect the RAID battery cable from the expansion-card riser board.
8
Remove the expansion-card cage. See "Removing the Expansion-Card Cage" in "Installing
System Options" in your Installation and Troubleshooting Guide.
9
Remove the memory module cover.
10
Remove the memory modules. See "System Memory" in "Installing System Options" in your
Installation and Troubleshooting Guide.
NOTE:
While removing the memory modules, record the memory module socket locations to ensure
proper installation on the new system board.
11
Remove the back fans and the back-fan tray.
12
If applicable, remove the RAC card. See "Installing a RAC Card" in "Installing System
Options" in your Installation and Troubleshooting Guide.
13
If applicable, remove the RAID key.
14
Remove the power supply(s). See "Power Supplies" in "Installing System Options" in your
Installation and Troubleshooting Guide.
15
Remove the processor(s). See "Processor" in "Installing System Options" in your Installation
and Troubleshooting Guide.
16
Raise the drive-bay retraction bar and swing it toward the front of the chassis to disengage the
SCSI backplane from the system board. See Figure 1-3.
Upgrading Your System Board and Riser Board
7