Dell PowerEdge 2850 사용자 설명서 - 페이지 10
{카테고리_이름} Dell PowerEdge 2850에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2850 30 페이지. Dell server quick reference
Dell PowerEdge 2850에 대해서도 마찬가지입니다: 설치 매뉴얼 (32 페이지), 지원 매트릭스 (21 페이지), 보충 설명서 (20 페이지), 정보 업데이트 (24 페이지), 매뉴얼 (44 페이지), 빠른 참조 (2 페이지)
페이지 인쇄
Condition
Identify drive
Drive being prepared for removal
Drive ready for insertion or removal Both drive indicators are off.
Drive being prepared for operation
Drive predicted failure
Drive failed
Drive rebuilding
Drive online
Back-Panel Features and Indicators
Figure 1-3
shows the controls, indicators, and connectors located on the system's back panel.
Figure 1-3. Back-Panel Features and Indicators
Connecting External Devices
When connecting external devices to your system, follow these guidelines:
Most devices must be connected to a specific connector and device drivers must be installed before the device operates properly. (Device drivers are
l
normally included with your operating system software or with the device itself.) See the documentation that accompanied the device for specific
installation and configuration instructions.
Always attach external devices while your system is turned off. Next, turn on any external devices before turning on the system (unless the
l
documentation for the device specifies otherwise).
For information about individual connectors, see your Installation and Troubleshooting Guide. For information about enabling, disabling, and configuring I/O ports
and connectors, see
"Using the System Setup
Power Indicator Codes
The power button on the front panel controls the power input to the system's power supplies. The power indicator can provide information on power status
(see Figure 1-4).
Table 1-4
lists the power button indicator codes.
Table 1-4. Power Button Indicators
Indicator
Function
On
Indicates that power is supplied to the system and the system is operational.
Off
Indicates that no power is supplied to the system.
Blinking
Indicates that power is supplied to the system, but the system is in a standby state. For information on standby states, see your operating
system documentation.
The indicators on the optional redundant power supplies show whether power is present or whether a power fault has occurred (see Figure 1-4).
lists the redundant power supply indicators.
Table 1-5. Redundant Power Supply Indicators
Indicator Pattern
The green power-on/fault indicator blinks four times per second.
The green power-on/fault indicator blinks two times per second.
The green power-on/fault indicator is on.
The power-on/fault indicator slowly blinks green, amber, and off.
The amber power-on/fault indicator blinks four times per second.
The green power-on/fault indicator blinks slowly.
The green power-on/fault indicator is on.
Program."
Table 1-5