Dell PowerEdge 2900 설치 매뉴얼 - 페이지 4

{카테고리_이름} Dell PowerEdge 2900에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 2900 10 페이지. Tower-to-rack conversion guide
Dell PowerEdge 2900에 대해서도 마찬가지입니다: 설치 정보 (11 페이지), 설치 매뉴얼 (14 페이지), 업데이트 (2 페이지), 매뉴얼 (26 페이지)

페이지 인쇄

Preparing the Optical Drive Tray – PowerEdge 2970, 2950, and 1950

For PowerEdge 2970 and 2950 systems, the optical drive tray that shipped

with the system is used for the SATA optical drive. If you are replacing an

existing IDE optical drive, you must remove the old drive and interposer card

from the drive carrier and install the new SATA drive in the same carrier.

On PowerEdge 1950 systems, the existing optical drive tray must be replaced

with the drive tray provided with the SATA drive installation kit.

The PowerEdge 2900 and 1900 systems do not require optical drive trays.

Replacing a PowerEdge 2950 or 2970 Optical Drive

NOTE:

If you are replacing an existing optical drive, do not reuse the interposer

board attached to the old drive.

1 Pull outward on the interposer board release tab at the back of the drive

tray to release the interposer board connected to the optical drive. See

Figure 1-1.

2 Pull the interposer board connector from the optical drive connector and

rotate the interposer board outward to detach the board from the tray.

3 Pull outward again on the interposer board release tab and simultaneously

pull up on the left side of the optical drive to separate the drive from the

tray.

4 Attach the SATA optical drive to the tray by lowering the right side of the

drive onto the right side of the tray. See Figure 1-1.

5 Lower the left side of the drive into the tray and press the drive down to

lock it into place.

The pins on the carrier fit into the corresponding holes in the side of the

drive.

Installing a SATA Optical Drive