Dell PowerEdge 4210 매뉴얼 - 페이지 9

{카테고리_이름} Dell PowerEdge 4210에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 4210 10 페이지. Cabling poweredge t610
Dell PowerEdge 4210에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지), 매뉴얼 (20 페이지), 매뉴얼 (17 페이지), 매뉴얼 (12 페이지), 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 매뉴얼 (9 페이지), 매뉴얼 (10 페이지), 설치 매뉴얼 (24 페이지), 매뉴얼 (12 페이지), 매뉴얼 (11 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

Cabling the Dell™ PowerEdge™ R610

Replacing a Power Supply on a PowerEdge R610 with CMA

1. Remove the tray from under the CMA as described in the CMA Installation Instructions provided with the CMA

kit.

2. Swing the CMA into the service position.

3. Disconnect the power cord from the power supply and disengage the strain relief.

4. Remove and replace the power supply

If the CMA is attached to the left side, both power supplies can be removed without disconnecting

the CMA.

b. If the CMA is attached to the right side and the inner power supply needs to be replaced, the CMA

does not need to be disconnected.

If the CMA is attached to the right side and the outer power supply needs to be replaced, the inner

CMA attachment housing will need to be disconnected. While supporting the CMA with one hand,

remove and replace the power supply with the other hand as shown in Figure 9.

Figure 9: Replacing Outer Power Supply

Inner CMA attachment housing has

been disconnected

5. Plug in the power cord.

6. Re‐engage the strain relief.

7. Return the CMA to the closed (retracted) position.

Page 7