Dell PowerEdge 4600 매뉴얼 - 페이지 9
{카테고리_이름} Dell PowerEdge 4600에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 4600 19 페이지. Poweredge 4600
Dell PowerEdge 4600에 대해서도 마찬가지입니다: 정보 업데이트 (14 페이지), 업데이트 매뉴얼 (42 페이지), 매뉴얼 (48 페이지), 설치 매뉴얼 (42 페이지), 제거 매뉴얼 (28 페이지), 설치 매뉴얼 (28 페이지), 매뉴얼 (15 페이지), 사양 (2 페이지)
페이지 인쇄
Pull the cable-management arm away from the cable tray.
4
Remove the captive thumbscrew and bracket that secure the back end of the cable-
5
management arm to the back vertical rail (see Figure 1-2).
Remove the five 6-32 x 0.25-inch hex-head Phillips that secure the cable tray to the
6
back of the system (see Figure 1-2).
Remove the cable tray from the back of the system.
7
Removing the System From the Rack
CAUTION: If you are removing more than one system from the rack cabinet,
remove the highest of the systems to be removed first. Complete the removal of
the first system from the rack before starting the second. Never extend more
than one system from the rack at a time. Removing a system from a position high
up in the rack cabinet may require up to four people and may require a sturdy,
elevated platform to stand on. A mechanical lifting platform or similar
equipment of the proper capacity may also be useful. If you attempt to remove
and lower the system without enough people to safely perform the task, you risk
personal injury to yourself and to others and damage to the system.
NOTICE: You will be moving the system chassis several times while you perform this
procedure. You may wish to make the system chassis lighter by labeling and removing
the hard drives and power supplies (for instructions, see the
Troubleshooting Guide
Loosen the thumbscrews that secure the system to the front vertical rails (at the front
1
of the rack cabinet).
Pull the system out of the rack until the green slide release latches lock at the fully
2
extended position.
Press up on the yellow system release latches and pull the system forward to the
3
farthest position on the slide assemblies (see Figure 1-3).
Using two to four people, grasp the system at each corner and lift the system up and
4
out of the slide asssemblies (see Figure 1-3).
If you have difficulty, ensure that the shoulder screws in the slide assemblies are
aligned with the openings on the top of the slide assemblies.
Place the system on a smooth work surface.
5
1-6
Rac k - t o-To we r Co n v ers io n G ui d e
).
Installation and