Dell PowerEdge 6400 조립 및 설치 - 페이지 6

{카테고리_이름} Dell PowerEdge 6400에 대한 조립 및 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 6400 32 페이지. Wake-on-lan (wol) support on dell servers
Dell PowerEdge 6400에 대해서도 마찬가지입니다: 랙 설치 (37 페이지), 업그레이드 설치 매뉴얼 (42 페이지), 랙 설치 (34 페이지), 설치 매뉴얼 (42 페이지), 설치 매뉴얼 (37 페이지), 매뉴얼 (10 페이지), 설치 (4 페이지), 매뉴얼 (10 페이지), 매뉴얼 (15 페이지)

페이지 인쇄

1-2

Installation Information

Press the system-board tray latch at the lower-back corner of the tray (see

Figure 1-1).

tray latch

Pull the tray open to the first slide position.

If any interface cables are connected between expansion card(s) and the small

computer system interface (SCSI) backplane board, disconnect the interface

cables from the SCSI backplane board.

7 .

Install the expansion-card cooling fan assembly (see Figure 1-2):

Insert the tabs at the bottom of the fan assembly into expansion-card bracket

at slots PCI2 and PCI6.

To identify slots PCI2 and PCI6, see "Expansion Cards" in your system's

Installation and Troubleshooting Guide.

Press the top of the fan assembly and slide it under the top of the expansion-

card bracket.

Secure the fan assembly bracket to the expansion-card bracket, and tighten

the fan assembly bracket thumbscrew.

NOTE: If you cannot install the fan assembly on the expansion-card bracket, replace

the expansion-card guides with those included in the fan assembly upgrade kit.

Locate an available connector on the DC power harness, and connect it to one of

the two fan assembly DC power connectors.

system board tray