Dell PowerEdge 6850 사용자 설명서 - 페이지 5

{카테고리_이름} Dell PowerEdge 6850에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 6850 29 페이지. Information update (.pdf)
Dell PowerEdge 6850에 대해서도 마찬가지입니다: 시스템 보드 교체 매뉴얼 (2 페이지), 정보 업데이트 (1 페이지)

페이지 인쇄

3. From the Connect to dropdown menu, select an available COM port, and then click OK.

After you select an available COM port, the COM port properties window appears.

4. Configure the port with the following settings:

Set Bits per second.

Console redirection supports only 9600, 19.2 K, 57.6 K, or 115.2 K bps.

Set Data bits to 8.

Set Parity to None.

Set Stop bits to 1.

Set Flow control to Hardware.

Click OK.

Configuring the Terminal Settings

1. In HyperTerminal, click File, click Properties, and then click the Settings tab.

2. Ensure that the Function, arrow, and Ctrl keys act as field is set to Terminal Keys.

3. Ensure that the Backspace key sends field is set to Ctrl+H.

4. Change the Emulation setting from Auto detect to ANSI or VT 100/220.

Ensure that this setting is the same as the setting you selected for the Console Redirection option on the host system.

5. Click Terminal Setup.

A setting for the number of rows and columns appears.

6. Change the number of rows from 24 to 25 and leave the number of columns at 80.

If you do not have these settings, you must upgrade your terminal emulation software.

7. Click OK twice.

Managing the Host System Remotely

After you configure the host and client systems (see

restart a host system or to change a host system's configuration settings.

1. Reboot the host system using the client system.

See

"Configuring Special Key

2. When the host system begins to boot, use console redirection to:

Enter the System Setup program

Enter the SCSI setup menus

Update firmware and BIOS (flash the system)

Run utilities on the utility partition

NOTE:

To run utilities on the host system's utility partition, you must have created the utility partition using Dell OpenManage™ Server Assistant

version 6.3.1 or later.

Configuring Special Key Functions

Console redirection uses ANSI or VT 100/220 terminal emulation, which is limited to basic ASCII characters. Function keys, arrow keys, and control keys are not

available in the ASCII character set, and most utilities require function keys and control keys for ordinary operations. However, you can emulate a function key

or control key using a special key sequence, called an escape sequence.

An escape sequence starts with an escape character. You can enter this character in different ways, depending on the requirements of your terminal

"Configuring the Host

Functions" for instructions.

System" and

"Configuring the Client

System"), you can use console redirection to