Dell PowerEdge 8450 정보 업데이트 - 페이지 4

{카테고리_이름} Dell PowerEdge 8450에 대한 정보 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge 8450 40 페이지. Information update
Dell PowerEdge 8450에 대해서도 마찬가지입니다: 정보 업데이트 (32 페이지), 정보 업데이트 (18 페이지)

페이지 인쇄

1-2

Dell PowerEdge 8450 Systems — Installing 1-GB DIMMs

You can upgrade system memory up to 32 GB by installing combinations of 128-,

256-, and 512-megabyte (MB), and 1-GB registered SDRAM DIMMs. Memory

upgrade kits can be purchased from Dell.

NOTE: The DIMMs must be rated to run at 100 megahertz (MHz) or faster.

The DIMM sockets are labeled "J1" through "J16" (see Figure 1-1). When you install

DIMMs, refer to the following guidelines:

To support 2:1 interleaving, you must configure the system with two memory

boards each with identical DIMM configurations in each socket location J1

through J16.

You must install DIMMs in pairs—one DIMM per memory board.

You may mix different sizes of DIMMs within a memory board.

For best performance, install DIMMs sequentially beginning with DIMM

socket J1.

To upgrade the system memory with 1-GB DIMMs, perform the following steps.

Turn off the system, including any attached peripherals, and disconnect all cables

from the back of the system and all power supplies from their electrical outlets.

Remove the front bezel (see "Checking Inside the Computer" in your system's

Installation and Troubleshooting Guide).

To remove the memory board cover, loosen the four captive thumbscrews secur-

ing the memory board cover to the front of the system chassis, and then pull the

cover directly away from the system (see Figure 1-2).