Dell POWEREDGE CLUSTER SL200 플랫폼 매뉴얼 - 페이지 11

{카테고리_이름} Dell POWEREDGE CLUSTER SL200에 대한 플랫폼 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell POWEREDGE CLUSTER SL200 18 페이지. Dell server user manual

support.dell.com

•

NICs

— You can install NICs in any available PCI slot.

•

DRAC 2

— If you are currently using a DRAC 2 or plan to use one in the future, install it

in PCI slot 6.

NOTE: To make sure that the SCSI or RAID controller attached to the boot drives

initializes first, you may have to change the scan order of the PCI bus, if the BIOS sup-

ports this option, or change the order of the RAID, NIC, and DRAC 2. Performing

these tasks ensures that Windows numbers the boot drives in the proper sequence.

Adding Peripherals Required for PowerEdge 2450 Cluster

Nodes

WARNING: Hardware installation should be performed only by trained

service technicians. Before working inside the computer system, see the

safety instructions in your PowerEdge system documentation to avoid a

situation that could cause serious injury or death.

The following list provides PCI slot assignment information for the system's buses,

RAID controllers, NICs, and DRAC 2.

NOTE: The PERC 2/DC comes fitted with an ISA retainer (the extension bracket at the

edge of the PCI card) to allow it to fit into a full-length ISA expansion slot. You may

need to remove the ISA retainer from systems that use full-length PCI expansion

slots. To remove the ISA retainer, use a Phillips screwdriver to remove the two screws

that fasten the retainer to the PERC 2/DC.

•

PCI buses

— PCI bus 1: PCI slots 1 through 3 are 32-bit, 33-MHz

•

RAID controllers

— RAID controllers can be installed in any available PCI slot.

•

NICs

— NICs can be installed in any available PCI slot. Dell recommends that Giganet

cLAN adapters be installed in PCI slots 1 or 2.

•

DRAC 2

— If you are currently using a DRAC 2 or plan to use one in the future, install it

in PCI slot 2.

NOTES: If you plan to use a DRAC 2, one PCI slot is available for a PERC 2/DC RAID

controller for shared storage.

To make sure that the SCSI or RAID controller attached to the boot drives initializes

first, you may have to change the scan order of the PCI bus, if the BIOS supports this

option, or change the order of the RAID, NIC, and DRAC 2. Performing these tasks

ensures that Windows numbers the boot drives in the proper sequence.

Dell PowerEdge Cluster SE100, SE200, and SL200 Platform Guide