Allied Telesis AT-9900 Series 기능 설명서 - 페이지 11
{카테고리_이름} Allied Telesis AT-9900 Series에 대한 기능 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Allied Telesis AT-9900 Series 18 페이지. How to set up pppoe between a linux client and access concentrator
Allied Telesis AT-9900 Series에 대해서도 마찬가지입니다: 구성 방법 (9 페이지), 방법 (8 페이지)
페이지 인쇄
Okay length
For example, this set of filters would work:
source MAC address
source UDP port
destination IP address + destination TCP port
The total number of bytes for the switch to check in a packet would be:
source MAC address + IP protocol type + source TCP/UDP port +
destination IP address + destination TCP/UDP port =
6 + 1 + 2 + 4 + 2 = 15 bytes
Too long
But this set of filters would not work:
source MAC address
destination MAC address
destination IP address + destination TCP port
The total number of bytes for the switch to check in a packet would be:
source MAC address + destination MAC address + IP protocol type +
destination IP address + destination TCP/UDP port =
6 + 6 + 1 + 4 + 2 = 19 bytes
Some protocols also use filters, so use some of the length
The following protocols use filters, and therefore use up some of the available profile length
and filter entries:
EPSR
EPSR matches on VLAN ID, which uses 2 bytes. EPSR is disabled by default.
IGMP
IGMP snooping matches on the IP protocol type field (to identify IGMP packets and send
them to the CPU). This uses 1 byte. IGMP snooping is enabled by default.
snooping
DHCP
DHCP snooping matches on the IP protocol type field (1 byte) and the source and
snooping
destination UDP ports (2 bytes each). Therefore, it uses 5 bytes in total. DHCP snooping is
disabled by default.
MLD
MLD snooping matches on the IPv6 router alert option and its value (2 bytes). MLD snooping
snooping
is enabled by default. If you are not using IPv6, you can turn off MLD snooping with the
command disable mldsnooping.
Page 11 | AlliedWare™ OS How To Note: Hardware Filters
How many filters can you create?