Dell PowerEdge M520 사용자 설명서 - 페이지 19

{카테고리_이름} Dell PowerEdge M520에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge M520 26 페이지. Dell poweredge blade servers getting started guide
Dell PowerEdge M520에 대해서도 마찬가지입니다: 정보 업데이트 (38 페이지), 릴리스 정보 (27 페이지), 매뉴얼 (25 페이지), 사용자 설명서 (23 페이지), 중요 정보 매뉴얼 (35 페이지), 업데이트 매뉴얼 (32 페이지), 업데이트 매뉴얼 (28 페이지), 사용자 설명서 (22 페이지), 시작하기 매뉴얼 (12 페이지), 기술 매뉴얼 (46 페이지), 기술 매뉴얼 (45 페이지), 포트폴리오 매뉴얼 (27 페이지), 시작하기 매뉴얼 (14 페이지), 시작하기 매뉴얼 (12 페이지)

Dell PowerEdge M520 사용자 설명서
Dell 10Gb Ethernet Pass Through II
4
Operating Procedures
4.1

Procedure for Updating Software

The 10GbE PTM consists of three PhyX® devices and a micro-controller (CPU). This procedure
describes how to update both CPU SW & PhyX® FW using a single .pfw binary file.
The 10GbE PTM is delivered with the latest firmware available at the time of production. New fir-
mare versions will be posted on the Dell support page. The latest firmware can be found at:
http://support.dell.com/support/
Step 1. Download the 10GbE PTM firmware .zip file and extract the .pfw binary file.
Step 2. Connect to the 10GbE PTM using an SSH Client as described in
the 10GbE PTM CLI," on page
Step 3. From the CMC command line, connect to the 10GbE PTM CLI. Enter:
Note:
At least 20 seconds must have passed since the last power cycle of the 10GbE PTM
module before running the following connect command.
$ connect switch-<n>
where <n> is the number of the switch -- 2 in our example.
The prompt should change to #.
Step 4. To start the upgrade process, run the command:
# copy image from-file
The system will now wait for a ".pfw" file to be transferred from the SSH client.
Step 5. In your SSH client, initiate file transfer by pulling down the Transfers menu and clicking
Send Files. Provide the path to the ".pfw" file and send it.
8.
Rev 1.00
Section 2, "Connecting to
19