Dell PowerEdge M915 매뉴얼 - 페이지 7

{카테고리_이름} Dell PowerEdge M915에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge M915 25 페이지. Dell poweredge blade servers getting started guide
Dell PowerEdge M915에 대해서도 마찬가지입니다: 릴리스 정보 (27 페이지), 사용자 설명서 (23 페이지), 중요 정보 매뉴얼 (35 페이지), 시작하기 매뉴얼 (12 페이지), 시작하기 매뉴얼 (12 페이지), 소유자 매뉴얼 (3 페이지), 포트폴리오 매뉴얼 (27 페이지), 시작하기 매뉴얼 (14 페이지), 시작하기 매뉴얼 (12 페이지)

Dell PowerEdge M915 매뉴얼
• Downlink (server blade) does not support the link protocol of the port group to which it is
attached
• Uplink (remote peer) does not support the link protocol of the port group to which it is attached
The following drawing demonstrates link protocol mismatch conditions:
Blade Configuration:
KR
KX4
KX
KR
KX4
KX
KX4
KX4
KR
KX4
KX
KR
KX4
KX
KX4
KX4
1.4

LED Behavior

The LED behavior is described in the following table:
Table 3 - LED Behavior
Condition
Link down
Figure 2: Link Protocol Mismatch Examples
Module Configuration:
SFP+ SR
SFP+ SR
SFP+ SR
SFP+ LR
SFP+ LR
SFP+ LR
No Cable
EMPTY
Passive Cable
Passive Cable
Passive Cable
SFP
SFP
SFP
SFP+ LRM
SFP+ LR, No Link
Green LED
Amber LED
off
off
Description
This condition occurs in the following cases:
Server blade not present, powered down, or link is
inactive
Uplink port module not present
Uplink port cable not connected
One or both of the internal and/or external links is
down
Rev 1.00
Link up
Blade is not KR
Blade is not KR
Link up
Blade is not KR
Blade is not KR
No cable detected
Module not present
Link up
Blade is not KR
Blade is not KR
Module is SFP (1GbE)
Module is SFP (1GbE)
Module is SFP (1GbE)
LRM module not supported
No link with remote side
7