Dell Poweredge metered 매뉴얼 - 페이지 4

{카테고리_이름} Dell Poweredge metered에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Poweredge metered 8 페이지. Cabling poweredge t610
Dell Poweredge metered에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지), 매뉴얼 (20 페이지), 매뉴얼 (17 페이지), 매뉴얼 (12 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 매뉴얼 (9 페이지), 매뉴얼 (10 페이지), 매뉴얼 (12 페이지), 매뉴얼 (12 페이지), 매뉴얼 (11 페이지)

Dell Poweredge metered 매뉴얼
Cable Routing Procedures for Dell™ PowerEdge™ T610 Systems

Introduction

This white paper covers recommended cable routing procedures for Dell™ PowerEdge™ T610
systems in the following racks:
PowerEdge™ 2410
PowerEdge™ 4210
PowerEdge™ 2420
PowerEdge™ 4220 (including wide and deep versions)
PowerEdge™ 4820 (including wide and deep versions)
If you are using the optional CMA, following these procedures will allow you to extend the system
from the rack for service without powering down or disconnecting the cables. If you are not using the
CMA, following these procedures will ensure secure attachment and strain relief of the cables behind
the system. For guidelines on how to route cables within the rack, refer to the Dell
Guide for Rack Enclosures
Section 1: Cabling a Dell™ PowerEdge™ T610 With a Cable Management
Arm (CMA)
This section details how to cable a PowerEdge™ T610 system using a CMA. If you are cabling the
system without the optional CMA, refer to Section 2.
Follow the instructions contained in the
the rack. Once installed, use these instructions to install the cables. All illustrations in the following
sections were created using a PowerEdge™ T610 system.
NOTE: PowerEdge™ T610 systems are compatible with the PowerEdge™ T710 rails and CMAs.

1.1 Connecting the CMA Cables to the System

Attach the CMA tray to the back of the rails as described in the
in the CMA kit. Connect all applicable cables to the rear of the system and verify that all connections
are secure. See Figure 1.

Figure 1: System with Cables Installed

white paper.
Rack Installation Guide
Best Practices
in the rail kit to install the server into
CMA Installation Instructions
provided
Page 2