Dell PowerEdge PDU Managed LED 매뉴얼 - 페이지 8

{카테고리_이름} Dell PowerEdge PDU Managed LED에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge PDU Managed LED 11 페이지. Site planning guide
Dell PowerEdge PDU Managed LED에 대해서도 마찬가지입니다: 매뉴얼 (20 페이지), 매뉴얼 (20 페이지), 매뉴얼 (17 페이지), 매뉴얼 (12 페이지), 매뉴얼 (10 페이지), 매뉴얼 (10 페이지), 매뉴얼 (9 페이지), 매뉴얼 (9 페이지), 매뉴얼 (10 페이지), 매뉴얼 (12 페이지), 매뉴얼 (12 페이지), 매뉴얼 (11 페이지), 매뉴얼 (8 페이지), 매뉴얼 (11 페이지), 매뉴얼 (11 페이지), 매뉴얼 (9 페이지), 사이트 계획 매뉴얼 (8 페이지)

페이지 인쇄

Cable Routing Procedures for Dell PowerEdge R320 & R420 Systems

Section 2: Replacing a hot swap power supply on a PowerEdge

R320 or R420 system with a CMA

2.1. Replacing a hot swap power supply with a left-side mounted CMA

1. Swing the CMA to its service position as described in the CMA Installation Instructions provided

with the CMA kit.

2. Remove the tray from underneath the CMA as described in the CMA Installation Instructions.

3. Disengage the strain relief and disconnect the power cord from the power supply.

4. Replace the power supply.

5. Plug in the power cord, re-engage the strain relief, replace the CMA support tray, and return the

CMA to the closed (retracted) position.

2.2. Replacing a hot swap power supply with a right-side mounted CMA

1. If the innermost power supply must be replaced, then follow the steps described in Section 2.1. If

the outermost power supply must be replaced, follow the steps described below.

2. Swing the CMA to its service position as described in the CMA Installation Instructions provided

with the CMA kit.

3. Remove the tray from underneath the CMA as described in the CMA Installation Instructions.

4. Disengage the strain relief and disconnect the power cord from the power supply.

5. Disconnect both CMA attachment housings from the brackets on the rails as shown in Figure 8.

6. Detach the inner CMA bracket from the rail by pushing on the end of the lock spring and lifting the

bracket up and to the left until it clears the standoffs on the rail.

7. While supporting the CMA with one hand, remove and replace the outer power supply with the

other hand as shown in Figure 9.

8. Reinstall the inner CMA bracket to the rail and reconnect the CMA to the brackets.

9. Plug in the power cord, re-engage the strain relief, replace the CMA support tray, and return the

CMA to the closed (retracted) position.