Dell PowerEdge PDU Metered LCD 매뉴얼 - 페이지 11

{카테고리_이름} Dell PowerEdge PDU Metered LCD에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge PDU Metered LCD 11 페이지. Site planning guide
Dell PowerEdge PDU Metered LCD에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 매뉴얼 (11 페이지), 매뉴얼 (9 페이지), 사이트 계획 매뉴얼 (8 페이지)

페이지 인쇄

Cable Routing Procedures for Dell PowerEdge R620 Systems

Section 4: Cabling a PowerEdge R620 system installed on static

rails

NOTE: The CMA is compatible only with the sliding rails, not the static rails.

1. Follow the instructions contained in the Rack Installation Instructions found in the static rail kit to

install the server into a two-post or four-post rack.

2. Install the hook-and-loop straps provided in the rail kit through the slots in the rear brackets of the

rails as described in the Rack Installation Instructions. If the slots in the rails are not accessible

due to the depth of the system and/or the spacing of the rack mounting flanges, install the hook-

and-loop straps onto the rack frame as shown in Figure 11.

3. Connect all applicable cables to the rear of the system and verify that all connections are secure.

4. Using the hook-and-loop straps, bundle the cables and secure them to either the left rail or right

rail as described in the Rack Installation Instructions. See Figure 11 for an example of data cables

secured to the left rail and power cables secured to the right rail (as viewed from the rear of the

system).

Figure 11.

Cabling a system installed in static rails

Install the hook-and-loop straps

onto the rack frame if the slots

in the rails are not accessible