Dell PowerEdge PDU Metered LCD 매뉴얼 - 페이지 7
{카테고리_이름} Dell PowerEdge PDU Metered LCD에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerEdge PDU Metered LCD 9 페이지. Site planning guide
Dell PowerEdge PDU Metered LCD에 대해서도 마찬가지입니다: 매뉴얼 (11 페이지), 매뉴얼 (11 페이지), 매뉴얼 (11 페이지), 사이트 계획 매뉴얼 (8 페이지)
페이지 인쇄
Cable Routing Procedures for the Dell PowerEdge T320 & T420 Systems
1.3.2. Right-side mounting instructions
1. Install the CMA on the rear right side of the rails by attaching both CMA housings to the attachment
brackets on the rails as described in the CMA Installation Instructions.
2. Route the cables through the CMA while avoiding twisting the cables. Use the hook-and-loop straps
on the CMA to secure the cables.
3. If the cable bundle includes a KVM SIP, its length may be too short for it to be placed inside the
CMA basket. Route the remainder of the cable that is beyond the SIP module through the CMA. DO
NOT secure the SIP to the outside of the CMA as this may restrict the ability of the CMA to support
full extension of the rails without causing damage to the SIP.
4. Once you have routed all of the cables through the CMA, dress the cable slack between the back of
the system and the entrance of the CMA using the tie wraps provided in the CMA kit.
5. Clip off the excess length of material from the tie wraps. Make sure that the heads of the tie wraps
are positioned so as to avoid interference with adjacent systems. Return the CMA to the closed
(retracted) position.
6. Extend the system out of the rack to verify that there is sufficient slack in the cables on both ends
of the CMA.
See Figure 5 for an example of a completed right-side mounted CMA installation.
Figure 5.
Right-side mounted CMA installation (CMA shown in service position)
KVM SIP placed outside the
basket for right-side mounting.
7