AVTronics AVT-QUAD2B 사용자 설명서 - 페이지 6

{카테고리_이름} AVTronics AVT-QUAD2B에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVTronics AVT-QUAD2B 8 페이지. 4 microphone wireless systems professional series

페이지 인쇄

1. Troubleshooting

Step 1

Verify that all equipment including the sound system is turned off.

Step 2

Attach power supply cord to receiver.

Step 3

Make sure you have batteries in each transmitter that you plan to use.

Step 4

Plug power supply cord from receiver into the wall.

Step 5

Plug receiver into sound system. Do this by either plugging in each channel

using the XLR outputs on the back of the receiver (each channel requires

one XLR cable) or by connecting one 1⁄4" cable to the sound board.

Note: If you want the sound technician to be able to adjust each channel individually on your

mixer, such as EQ, volume, and auxiliary send, you must use the XLR outputs, not the 1⁄4"

output. Turn the channel volume controls on the receiver all the way up and mix indepen-

dently on your mixer. If you use the 1⁄4" output you must adjust (mix) your volume levels on

the front of your receiver.

Step 6

Turn on receiver.

Step 7

Turn on transmitters.

Step 8

Adjust individual volume controls to desired levels.

PROBLEM

The receiver has no power.

Transmitter has no power.

The volume of each microphone is

not at the the same level coming

through the sound board.

The sound is coming through on the

same channel for all 4 microphones

and as a result cannot be adjusted

individually.

Feedback

GETTING STARTED

TROUBLE SHOOTING

Check to make sure the power cord is

plugged in and the switch is put to the

"on" position.

Make sure the switch has been put to

the "on" position. If the unit is still not

working then check the batteries in the

transmitter. Each unit requires 2 AA

batteries.

Check to make sure the volume knobs

on the receiver are all turned to the

same position or all the way on.

Use 4 individual XLR cables to plug into

the sound board instead of the 1⁄4" cable.

The microphone user may be too close

to a speaker or stage monitor while the

microphone is in use.

POSSIBLE SOLUTION