Dell PowerVault DL4000 배포 매뉴얼 - 페이지 15

{카테고리_이름} Dell PowerVault DL4000에 대한 배포 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault DL4000 22 페이지. Setting up your dell powervault dl4000 backup to disk appliance
Dell PowerVault DL4000에 대해서도 마찬가지입니다: 핸드북 (28 페이지), 릴리스 노트 (11 페이지), 시작하기 매뉴얼 (10 페이지), 매뉴얼 (4 페이지), 매뉴얼 (2 페이지), 시스템 시작하기 (2 페이지)

페이지 인쇄
Dell PowerVault DL4000 배포 매뉴얼

Teaming Network Adapters

By default, the network adapters (NICs) on the DL4000 Backup to Disk Appliance are not bonded, which affects the
performance of the system. It is recommended that you team the NICs to a single interface. Teaming the NICs require:
•
Reinstalling the Broadcom Advanced Control Suite
•

Creating the NIC team

Reinstalling Broadcom Advanced Configuration Suite

To reinstall Broadcom Advanced Configuration Suite:
1.
Go to C:\Install\BroadcomAdvanced and double-click setup.
The InstallShield Wizard is displayed.
2.
Click Next.
3.
Click Modify, Add, or Remove.
The Custom Setup window is displayed.
4.
Click CIM Provider, and then select This feature will be installed on local hard drive.
5.
Click BASP, and then select This feature will be installed on local hard drive.
6.
Click Next.
7.
Click Install.
8.
Click Finish.
Creating The NIC Team
To create NIC teaming:
1.
Go to Start → All Programs → Broadcom → Broadcom Advanced Control Suite.
2.
In the Broadcom Advanced Control Suite, select Teams → Go to Team View.
3.
In the Hosts list on the left side, right-click on the host name of the DL4000 appliance and select Create Team.
The Broadcom Teaming Wizard window is displayed.
4.
Click Next.
5.
Enter a name for the team and click Next.
6.
Select the Team Type and click Next.
7.
Select an adapter you want to be part of the team, and click Add.
8.
Repeat these steps for all other adapters that are a part of the team.
9.
When all adapters are selected for the team, click Next.
10. Select a standby NIC if you want a NIC that can be used as the default, if the team fails.
11. Select whether to configure LiveLink, and then click Next.
12. Select Skip Manage VLAN and click Next.
13. Select Commit changes to system and click Finish.
14. Click Yes when warned that the network connection is interrupted.
NOTE: The building of the team may take about 5 minutes.
15