DH Wireless Solutions PDN Genesis S2 현장 매뉴얼 - 페이지 12
{카테고리_이름} DH Wireless Solutions PDN Genesis S2에 대한 현장 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DH Wireless Solutions PDN Genesis S2 20 페이지.
페이지 인쇄PDN Genesis
S2
Problem/
Possible
Symptom
Main power
switch is
in "OFF"
position
AC cable
is not
connected
firmly
Fuse is
blown
Reverse
polarity
of battery
connections
Battery or
charger
is not
connected
www.portablessupport.com
Field Manual
Cause
Battery gauge displays a red
LED signal when batteries are
connected. Batteries are
disconnected when the main
power switch is off and
therefore will not charge.
Inspect both ends of
AC power cable to ensure
they are both seated fully in
receptacles.
Remove service cover.
Open black rubber cover
on fuse holder connected
to battery charger. Remove
fuse and check if center
strip is intact.
Remove service cover.
Check LED lights on battery
charger. If orange solid LED
appears, battery polarity is
reversed.
Remove service cover.
Check LED lights on battery
charger. If LED lights alternate
red and green, battery is
not connected. Solid red
indicates charging. Solid
green indicates full charge.
Verification
12
Possible
Corrections
Open case and ensure
Main Power Switch
in upper left corner
of service cover is in
the "ON" position.
AC cable must be pressed
firmly and completely into
a live receptacle.
Replace the fuse with a
mini blade fuse of the
same amperage rating
printed on the top of
the fuse.
Reverse battery connections
ensuring positive red wire
is connected to positive
red battery terminal and
negative black wire is
connected to the negative
black battery terminal.
Verify electrical terminals
on the wire harness are not
contaminated and are
firmly connected to the
battery and the battery
charger.