Dell PowerVault MD3220 Series 사용자 설명서 - 페이지 21

{카테고리_이름} Dell PowerVault MD3220 Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PowerVault MD3220 Series 46 페이지. Storage arrays
Dell PowerVault MD3220 Series에 대해서도 마찬가지입니다: 업데이트 매뉴얼 (32 페이지), 랙 설치 지침 (2 페이지), 배포 매뉴얼 (38 페이지), 정보 업데이트 (1 페이지), 기술 매뉴얼북 (40 페이지), 배포 매뉴얼 (38 페이지), 배포 매뉴얼 (38 페이지)

페이지 인쇄

Figure 13. Port Name Binding

2 Using the vSphere CLI, connect the software iSCSI initiator to the iSCSI

VMkernel ports. Repeat this command for each port.

esxcli swiscsi nic add -n <port_name> -d <vmhba>

3 Verify that the ports were added to the software iSCSI initiator by running

the following command:

esxcli swiscsi nic list -d <vmhba>

4 Use the vSphere Client to rescan the software iSCSI initiator.

5 To disconnect the software iSCSI initiator from the ports, run the

following command:

esxcli swiscsi nic remove -n <port_name> -d

<vmhba>

If there are active iSCSI sessions between your host and targets,

discontinue them before running this command. You can do so by

removing static targets that the ports use from the vSphere Client.

esxcli swiscsi nic remove -n <port_name> -d

<vmhba>

Example 2: Connecting Software iSCSI Initiator to Two VMkernel Ports

This example shows how to connect the software iSCSI initiator vmhba33 to

VMkernel ports vmk1 and vmk2.

1 Connect vmhba33 to vmk1:

esxcli swiscsi nic add -n vmk1 -d vmhba33

2 Connect vmhba33 to vmk2:

esxcli swiscsi nic add -n vmk2 -d vmhba33

Dell MD Storage Array vCenter Plug-in