Dell PS4110 하드웨어 사용 설명서 - 페이지 32
{카테고리_이름} Dell PS4110에 대한 하드웨어 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell PS4110 48 페이지. Storage arrays
Dell PS4110에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지), 하드웨어 매뉴얼 (50 페이지), 개요 (7 페이지), 설치 (2 페이지)
페이지 인쇄
Hardware Owner's Manual
To install a control module:
1. Attach an electrostatic wrist strap, or similar protective device.
2. Push down on the orange release tab (callout 1 in following illustration) and swing the lever (callout 2 in
following illustration) out.
3. Slide the control module into the chassis until you feel resistance, as shown in following illustration.
4. Rotate the lever (callout 2 in illustration) inward, which pushes the control module completely into the slot.
The latch on the lever will snap into place.
5. Reconnect the network cables.
6. If the array was shut down, turn on power to the array.
7. Make sure the control module is operational. See
When connected, the control module cache-to-flash module receives full charge. If it cannot be charged, its
status is reported as BAD in the Group Manager GUI. You must remove the control module and replace it
with another one.
28
Figure 18: Correct Control Module Orientation
Figure 19: Installing a Control Module (2U Array)
See "Protecting Hardware " on page
Interpreting Control Module LEDs on page
3 Maintaining Control Modules
19.
2.