Dell V570F 소유자 매뉴얼 - 페이지 28

{카테고리_이름} Dell V570F에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell V570F 35 페이지.
Dell V570F에 대해서도 마찬가지입니다: 소유자 매뉴얼 (37 페이지), 소유자 매뉴얼 (35 페이지)

Pre-operating system management

applications

You can manage basic settings and features of the VxRail without booting into the operating system by using the system

firmware.

Dell Technologies optimizes your VxRail with the settings during installation and configuration. Do not change any basic settings

or features set by Dell Technologies to ensure best performance.

CAUTION:

Performance may be impacted if settings and features configured by Dell Technologies are changed.

VxRail contains options to manage the pre-operating system applications.

The following options are available:

● System Setup

● Boot Manager

● Dell Lifecycle Controller

● Preboot Execution Environment (PXE)

Your VxRail was optimized by Dell Technologies during the initial configuration. Do not change any of the basic settings or

features set by Dell Technologies to ensure best performance.

The Integrated Dell Remote Access Controller (iDRAC) allows administrators to be more productive and improve the overall

availability of Dell products. iDRAC alerts administrators to issues, perform remote management, and reduce the need for

physical access.

You can log in to iDRAC as the following users:

● iDRAC user

● Microsoft Active Directory user

● LDAP user

If secure default access to iDRAC is used, the iDRAC secure default password is available on the back of the appliance

Information tag. If you have not opted for secure default access to iDRAC, then the default user name and password are root

and calvin. You can also log in by using Dell SSO or Smart Card.

The following prerequisites are a must to log in to iDRAC:

● You must have iDRAC credentials.

● Change the default user name and password after setting up the iDRAC IP address.

The iDRAC IP address is pre-configured for DHCP. This can be changed to a static IP address by logging into iDRAC.

● To access iDRAC, connect the network cable to the Ethernet connector 1 on the system board.

● Change the default username and password after setting up the iDRAC IP address.