Dell Vostro 220 - Vostro 220 Slim Desktop Computer 서비스 매뉴얼 - 페이지 17
{카테고리_이름} Dell Vostro 220 - Vostro 220 Slim Desktop Computer에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell Vostro 220 - Vostro 220 Slim Desktop Computer 44 페이지. Rack installation guide
Dell Vostro 220 - Vostro 220 Slim Desktop Computer에 대해서도 마찬가지입니다: 사양 (1 페이지), 설정 및 기능 정보 (10 페이지), 랙 설치 매뉴얼 (40 페이지)
페이지 인쇄
POWER_2
PROC_0
PROC_1
SER
STANDBY
STR
USB
TAPI
WUOL
RIMMs
To remove a Rambus in-line memory module (RIMM), perform the following steps.
CAUTION: Before you remove the computer cover, see
NOTE: Before disconnecting a peripheral from the system or removing a component from the system board, disconnect the power
cable and verify that the standby power LED on the system board is off. For the location of this LED, see Figure 21.
1.
Remove the computer
cover.
Rotate the system power supply
2.
3. Press the securing clips outward simultaneously until the RIMM disengages and pops out slightly from the socket (see
Figure 23. Removing a RIMM
To reinstall a RIMM, perform the following steps.
1. Locate the plastic securing clips at each end of the socket (see
2. Press the clips outward until they snap open.
3. Press the RIMM straight into the slot running down the center of the socket until the securing tabs snap into place around the ends of the
RIMM.
After you
replace the computer cover
Figure 24. Installing a RIMM
Microprocessor/Heat Sink Assembly
To replace a microprocessor, perform the following steps.
3.3-V power input connector
Primary microprocessor connector
Secondary microprocessor connector
Serial port connectors
Standby power LED
Suspend-to-RAM LED
USB connectors
Telephony connector
Remote Wakeup power connector
to allow you to access the RIMMs.
1 Securing clips (2)
and
restart the
system, run the Dell Diagnostics to verify that the RIMMs are operating properly.
1 Securing clips (2)
2 Notches (2)
"Precautionary
Measures."
Figure
24).
Figure
23).