EarthCore PET-30P 소유자 매뉴얼 - 페이지 10

{카테고리_이름} EarthCore PET-30P에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EarthCore PET-30P 18 페이지.

페이지 인쇄

This instruction contains suggested log placement for the Iso-Flames log set. Some ﬂ exibility is possible

in log placement to suit your individual preference provided excessive sooting does not result from ﬂ ames

striking the logs too directly (see Important below). The suggested log placement will allow for superior ﬂ ame

pattern, appearance, and adequate ventilation. Please read these instructions completely and carefully

before beginning.

Important:

Although there is some ﬂ exibility with the log placement, adequate spacing between the

logs is NECESSARY and MUST be maintained. Some carbon build up (sooting) may occur

where the ﬂ ames strike the logs, and should not be a concern, unless excessive. If sooting

is excessive, rearrange the top logs to allow more opening(s) for the ﬂ ame(s).

CAUTION: BURN HAZARD! Logs will remain hot for some time after use. If you need to reposition

any log to maintain the proper layout, use heat-resistant gloves or allow logs adequate time

to cool before handling.

Note: Highlighting added to improve clarity.

Fig. 10-1

Fig. 10-2

Fig. 10-3

Fig. 10-4

LOG PLACEMENT

Each log in this gas log set is numbered here to aid

in the log placement procedure.

1. Prior to log placement, be sure the glowing embers

were placed as discussed in the GLOWING EMBER

PLACEMENT section.

2. Set the bottom rear log #1 at the rear of the grate

(Fig. 10-1). Center the log, with its back up against the

burner tabs.

3. Set the bottom left and right logs #2-3 at the front of

the burner with the charred ends facing inward. Leave

a small gap in between the two charred ends. (Fig.

10-2). Center the logs, with their backs up against

the burner tabs. (The bottom left log is longer and will

slightly stick outward more than the bottom right log.)

4. Position the middle center log #4 on the left side of the

log set, resting on logs #1 and #2 as shown. Position

the middle center log #5 in a similar manner (with

more of an angle), toward the center of the log set.

(Fig. 10-3.)

5. Position the middle right log #6 on the right side of

the log set, resting on logs #3 and #5 as shown in Fig.

10-4.

6. Position the top left log #7 at a slight angle on top of

logs # 4 and #5 as shown. The charred end should rest

downward. Complete log placement by positioning the

top right log #8 at an angle on top of log #6, with the

bottom end resting in between the charred section of

logs #1 and #2 (Fig. 10-5.)

Fig. 10-5