Avue AVL240SDI 사용자 설명서 - 페이지 4

{카테고리_이름} Avue AVL240SDI에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avue AVL240SDI 18 페이지.

Installation

Do not install the unit in an extremely hot or humid place or in a place subject to

excessive dust or mechanical vibration.

The unit is not designed to be waterproof. Exposure to rain or water may damage the

unit.

Cleaning

Clean the unit with slightly damp soft cloth. Use a mild household detergent. Never use

strong solvents such as thinner or benzene as they might damage the finish of the unit.

Retain the original carton and packing materials for safe transport of this unit in the

future.

Safety Precautions:

Federal Communications Commission (FCC) Statement

This Equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

 You are cautioned that changes or modifications not expressly approved by the

party responsible for compliance could void your authority to operate the

equipment.

This device complies with Part 15 FCC Rules. Operation is subject

to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received including

interference that may cause undesired operation.