Dell 2009WFP 사용자 설명서 - 페이지 12
{카테고리_이름} Dell 2009WFP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dell 2009WFP 27 페이지. Flat panel monitor
페이지 인쇄C
Use this button for direct access to the "Brightness" and "Contrast" control menu.
Brightness/Contrast
Hot Key
C
Use these buttons to navigate and adjust the slider-bar (decrease/increase ranges) controls in the OSD.
and
D
Down (-) and Up (+)
D
Use this button to activate automatic setup and adjust menu. The following dialog appears on a black screen as the monitor self-
adjusts to the current input:
Auto Adjust
Auto Adjustment allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can further tune
your monitor by using the Pixel Clock (Coarse) and Phase (Fine) controls under DISPLAY SETTINGS.
NOTE: Auto Adjust does not occur if you press the button while there are no active video input signals or attached cables.
E
Use the Power button to turn the monitor on and off.
The green LED indicates the monitor is on and fully functional. An amber LED indicates DPMS power save mode.
Power button
(with power light
indicator)
Using the On-Screen Display (OSD) Menu
Accessing the Menu System
NOTE:
If you change the settings and then either proceed to another menu or exit the OSD menu, the monitor automatically saves those changes. The
changes are also saved if you change the settings and then wait for the OSD menu to disappear.
1.
Push the MENU button to launch the OSD menu and display the main menu.
Main Menu for Analog (VGA) Input
or
Main Menu for non Analog (non VGA) Input
NOTE:
AUTO ADJUST is only available when you are using the analog (VGA) connector.
2.
Push the
and
buttons to move between the setting options. As you move from one icon to another, the option name is highlighted. See the
following table for a complete list of all the options available for the monitor.
3.
Push the MENU button once to activate the highlighted option.
4.
Push the
and
buttons to select the desired parameter.
5.
Push
to enter the slide bar and then use the
6.
Select the "back" option to return to the main menu or "exit" to exit the OSD menu.
Icon
Menu and
Description
Submenus
or
button, according to the indicators on the menu, to make your changes.